Pilaster Mounting Dogs
Pilaster Mounting Dogs for milling flat column faces
Cut the stock to width
Cut the four pieces of stock the width of the pilaster mounting dogs and the desired length. Drill a 13/16" hole centered on the stock and 1/2" from the end. If the stock is longer than 24" you may want to cut blocks the same size as the pilaster dogs. 		Cut the stock to width
Attach the stock
Using the cap screws provided, attach the 4 pieces of stock to the pilasters dogs. Insert the blocks in the center if necessary. 		Attach the stock
Attach the Index Hub
Attach a Index Hub to one end. This end will engage with the Index Drive on the spindle shaft in the Headstock. 		Attach the Index Hub
Mill the stock
Mill the stock as if it were a solid column, adding any desired details. Then remove the four pieces and repeat for as many parts as necessary. 		Mill the stock
Finished Sample
Here you can see the fluted column faces that were created using the pilaster mounting dogs. 		Finished Sample